first of all use the nslu2-linux group for nslu2-linux custom
firmware usage questions
http://groups.yahoo.com/group/nslu2-linux/?yguid=184009766
---
ssh you need to acess your slug but can be replaced by telnet so
install telnet then remove ssh, telnet take less resources.
klogd and syslogd can be disabled, and samba to if you dont use it.
I must warn you [Im no expert] but I have run my slug with thoose
removed long time ...still up=).
and I think Openlsug is better for mldonkey becuse it uses less mem.
--- In nslu2-general@xxxxxxxxxxxxxxx, "factinmyosin"
<factinmyosin@...> wrote:
>
> My slug is running debian etch, it is used for mldonkey only.
> When mldonkey is running, it's really slow to respond to any
commands.
> Found most memory (~29M) is used, only ~ 1M is free, while the total
> is ~30M
>
> Run rcconf, the following services are on, which one could be
stopped
> to save memory?
>
> klogd
> sysklogd
> makedev
> zleds
> samba
> ssh
> mldonkey-server
>
> some others are turned off, but still listed there, Can I save more
> memory if "apt-get remove"
>
> Can I mount a USB pindrive to swap, will that speed up this slug?
will
> the usb pindrive die soon?
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/nslu2-general/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/nslu2-general/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:nslu2-general-digest@xxxxxxxxxxxxxxx
mailto:nslu2-general-fullfeatured@xxxxxxxxxxxxxxx
<*> To unsubscribe from this group, send an email to:
nslu2-general-unsubscribe@xxxxxxxxxxxxxxx
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|